I installed the plugin and the iTach WF2IR devices created automatically. Everything (hardware wise) appears fine and dandy.
I then sat down and used the iLearn to learn the Sony Remote for my old Receiver (STR-DE695). This setup will be going into the garage.
I saved the file.
And loaded it in the plugin. Ensured that the codes imported.
Then... I tried to test turning the receiver on... no dice.
I went back to iLearn and re-learned the Power button on the remote. Tried to "Send IR" and nothing happened.
Googled / Youtubed but I'm at a loss.
I've changed the ports and switched between the ir blaster and ir emitters and nothing changes.
Is there some secret handshake that I'm missing here?
I then sat down and used the iLearn to learn the Sony Remote for my old Receiver (STR-DE695). This setup will be going into the garage.
I saved the file.
And loaded it in the plugin. Ensured that the codes imported.
Then... I tried to test turning the receiver on... no dice.
I went back to iLearn and re-learned the Power button on the remote. Tried to "Send IR" and nothing happened.
Googled / Youtubed but I'm at a loss.
I've changed the ports and switched between the ir blaster and ir emitters and nothing changes.
Is there some secret handshake that I'm missing here?
Comment