VOLUME CONTROL PROBLEM

[gelessor]

I have created a couple volume events but any that increase the volume do not work. Volume Down and Mute work fine. Setter a volume to a particular number works... but any command to simple increase thew volume by 1 or 3 does not work.

Pioneer VSX-25

Help. Why does the below command not work?

PAVR2 Master Controls UltraPioneerAVR3 Plugin PAVR2 Master Controls PAVR2 Volume to Increase 3dB

[Ultrajones]

If you select the volume control from the HomeSeer device web page, then select Increase +1 or Increase +3, does that increase the volume? If not, what's written to the logs?

[gelessor]

VERY STRANGE.. If I run as you suggested above, it works. But when I try to do so from an event it does not work. See the log and event configurations below.

As a side note - If I create an event to go to a defined volume (like -35) it works just as the Volume Down Event does. It's only when I try to run a Volume Up event that is does not work.

[gelessor]

Anyone have any ideas why the volume up will not work within an event?