Announcement

Collapse
No announcement yet.

Error in Log

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • CharlieWayne
    replied
    Yes, network standby is on.

    This error reports when the amp is on and in use. I'm not sure if it also logs when the amp is off in standby.

    So far today, I haven't seen any log errors.

    Leave a comment:


  • Ultrajones
    replied
    Originally posted by CharlieWayne View Post
    Hello Ultra.

    I created more devices than I should have, and as result was getting response errors. I was able to fix them all by unchecking the HS device option within you plugin and also deleting the device from HS.

    This one I cant figure out what its for. My Amp is a SC-1223

    Charlie
    Do you have your receiver setup to keep the network active while powered off?

    Leave a comment:


  • CharlieWayne
    replied
    I had Zone 3 (or something like that) enabled within the plugin and it created this error also. When I unclicked it and deleted the he device, I never seen that error again.

    The error line is often but it hasn't happened as of midnight yet.

    Were using Insteon keypads to power the amp on/off through HS events. Sometimes the amp will not respond to power off.

    Leave a comment:


  • Ultrajones
    replied
    The number of devices created as no relationship to the error you're seeing. The error/warning indicates your receiver didn't response to the power status request. How often do you see that error in your logs?

    Regards,
    Ultrajones

    Leave a comment:


  • CharlieWayne
    started a topic Error in Log

    Error in Log

    Hello Ultra.

    I created more devices than I should have, and as result was getting response errors. I was able to fix them all by unchecking the HS device option within you plugin and also deleting the device from HS.

    This one I cant figure out what its for. My Amp is a SC-1223

    Charlie


    9/12/2014 6:42:58 PM UltraPioneerAVR Warning No response/improper response from Pioneer AVR device '192.168.1.15:8102' to command '?P'. Your Pioneer AVR may not support the feature 'Power'.
    9/12/2014 6:42:53 PM UltraPioneerAVR Warning No response/improper response from Pioneer AVR device '192.168.1.15:8102' to command '?P'. Your Pioneer AVR may not support the feature 'Power'.
Working...
X