Announcement

Collapse
No announcement yet.

Unable to initialize X10 interface TI 103:

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Unable to initialize X10 interface TI 103:

    "Either no license or trial has expired"

    I deleted the file, ran the Updater and downloaded the Plugin again. Restarted HS. Same message. Help! please

    #2
    Can you please put in a help desk request bug report on this. Also include the exact error out of the HS log file.
    -Rupp
    sigpic

    Comment


      #3
      Thanks Greg. Done. Guess it's back to the CM11a.

      Comment


        #4
        Would you please post the init section of your logfile that contains the Ti errors here as well. Please include the entries just prior and just after the errors as well.
        Best regards,
        -Mark-

        If you're not out on the edge, you're taking up too much room!
        Interested in 3D maps? Check out my company site: Solid Terrain Modeling

        Comment


          #5
          This is an on going issue where the settings.ini file get truncated when HomeSeer writes the settings.ini file for gSelectedx10Interface= I replied to the help desk ticket and will assign the ticket to Rich as we need to get this solved.
          -Rupp
          sigpic

          Comment


            #6
            Understood - thanks for the clarification.
            Best regards,
            -Mark-

            If you're not out on the edge, you're taking up too much room!
            Interested in 3D maps? Check out my company site: Solid Terrain Modeling

            Comment

            Working...
            X