I suspect I have an installation problem but I have review the threads here and can not find anything that would point me in the right direction. I installed the Envi on July 24th, v1.0.0.31 of the plugin on the 25th and all looked fine for almost 24 hours. Then it stopped updating the HS devices, graphs, etc. The HS log continued showing updates for sensors 0 - 9 (I only have the main unit):
8/2/2010 3:00:19 PM ~!~Current Cost~!~Updating projected value for Sensor 0
Today, I went in and updated to v1.0.039. It appears the update went go ok, I didnt get any errors and nothing shows when I restarted HS. However, during startup I received the message:
8/2/2010 3:04:44 PM ~!~Current Cost~!~Updating ALL projected values
I have not received any of the sensor update messages (above), that were appearing about every 15 minutes in the prior version. It is still not updating the devices. I have attached a partical log and my Current Cost ini. Help would be greatly appreciated.
I downloaded and started the PowerSave C2 Terminal to test the Envi. I opened the port (21) and nothing else showed on the screen for about 5 minutes. I closed C2 and restarted HS. Could I have a defective Envi? Is there a setting on the Monitor that tells it to, or allows it to download data via the USB cable?
Thanks
Gary
8/2/2010 3:00:19 PM ~!~Current Cost~!~Updating projected value for Sensor 0
Today, I went in and updated to v1.0.039. It appears the update went go ok, I didnt get any errors and nothing shows when I restarted HS. However, during startup I received the message:
8/2/2010 3:04:44 PM ~!~Current Cost~!~Updating ALL projected values
I have not received any of the sensor update messages (above), that were appearing about every 15 minutes in the prior version. It is still not updating the devices. I have attached a partical log and my Current Cost ini. Help would be greatly appreciated.
I downloaded and started the PowerSave C2 Terminal to test the Envi. I opened the port (21) and nothing else showed on the screen for about 5 minutes. I closed C2 and restarted HS. Could I have a defective Envi? Is there a setting on the Monitor that tells it to, or allows it to download data via the USB cable?
Thanks
Gary
Comment