Announcement

Collapse
No announcement yet.

AP800 and PZM-11. How to connect?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    AP800 and PZM-11. How to connect?

    Hi all,

    HA noob here, I just bought an AP800 and a few PZM11s. I have a 22 gauge, two conductor jacketed cable with an overall shield and drain wire. ( Two Conductors Plus Ground).
    I connect the red to +, the black to - and the ground wire to ground in the microphone.
    Then I connect the same to the Phoenix connector in the back of the AP800. But the mic does not work.
    How do I provide Phantom power to it? Thanks!!!

    #2
    Check the settings on the AP800. It has to be told to apply phantom power to the specified mic. Your connections are correct.

    Dan

    Comment

    Working...
    X