So I've placed my order for a new Pentair SuperFlo VS Variable Speed Pump which has a connector on it for automated control (generally through a Pentair controller). However, in reading the documentation, if I have 3 relays using the supplied 5 volts from the pump, I can select any of 3 operating modes.
So thinking (with eyes wide open ) that I can control this with HS for remote control. Is there a 3 (min) relay controller I can use to do this? This will give me speed1, speed2 and off.
I was looking at the Mimolite module but at most it supports 2 relays. Is there another solution?
I have in my pool shed, eithernet, X-10 and hopefully Z-wave if it will make it - about 55-60 ft.
Any suggestions?
Robert
So thinking (with eyes wide open ) that I can control this with HS for remote control. Is there a 3 (min) relay controller I can use to do this? This will give me speed1, speed2 and off.
I was looking at the Mimolite module but at most it supports 2 relays. Is there another solution?
I have in my pool shed, eithernet, X-10 and hopefully Z-wave if it will make it - about 55-60 ft.
Any suggestions?
Robert
Comment