Hi All....
I got a MIMO2+ that I want to simply control the relay outputs.
I set Parameters 1&2 to 0 in order to latch the relays. All other parameters remain at their default.
The relays respond to On/Off commands and work as expected.
The only problem is that Homeseer doesnt reflect their status, it always stays "Unknown" as shown below.
Would appreciate any pointers as I would like to use the status values in events.
This is what is shown in the log:
Jan-08 9:32:57 PM Z-Wave Device: Z-Wave Switch Binary 4 Set to INVALID VALUE
Jan-08 9:32:57 PM Device Control Device: Z-Wave Switch Binary 4 to Off (0) by/from: CAPI Control Handler
Jan-08 9:32:55 PM Z-Wave Device: Z-Wave Switch Binary 4 Set to INVALID VALUE
Jan-08 9:32:54 PM Device Control Device: Z-Wave Switch Binary 4 to On (255) by/from: CAPI Control Handler
Jan-08 9:32:53 PM Z-Wave Device: Z-Wave Switch Binary 3 Set to INVALID VALUE
Jan-08 9:32:53 PM Device Control Device: Z-Wave Switch Binary 3 to Off (0) by/from: CAPI Control Handler
Jan-08 9:32:49 PM Z-Wave Device: Z-Wave Switch Binary 3 Set to INVALID VALUE
Jan-08 9:32:49 PM Device Control Device: Z-Wave Switch Binary 3 to On (255) by/from: CAPI Control Handler
I got a MIMO2+ that I want to simply control the relay outputs.
I set Parameters 1&2 to 0 in order to latch the relays. All other parameters remain at their default.
The relays respond to On/Off commands and work as expected.
The only problem is that Homeseer doesnt reflect their status, it always stays "Unknown" as shown below.
Would appreciate any pointers as I would like to use the status values in events.
This is what is shown in the log:
Jan-08 9:32:57 PM Z-Wave Device: Z-Wave Switch Binary 4 Set to INVALID VALUE
Jan-08 9:32:57 PM Device Control Device: Z-Wave Switch Binary 4 to Off (0) by/from: CAPI Control Handler
Jan-08 9:32:55 PM Z-Wave Device: Z-Wave Switch Binary 4 Set to INVALID VALUE
Jan-08 9:32:54 PM Device Control Device: Z-Wave Switch Binary 4 to On (255) by/from: CAPI Control Handler
Jan-08 9:32:53 PM Z-Wave Device: Z-Wave Switch Binary 3 Set to INVALID VALUE
Jan-08 9:32:53 PM Device Control Device: Z-Wave Switch Binary 3 to Off (0) by/from: CAPI Control Handler
Jan-08 9:32:49 PM Z-Wave Device: Z-Wave Switch Binary 3 Set to INVALID VALUE
Jan-08 9:32:49 PM Device Control Device: Z-Wave Switch Binary 3 to On (255) by/from: CAPI Control Handler
Comment