Newbie w/ HS - Looking at Converting from SmartThings after a couple years.
I have older GE/Jasco wall switches and would like that when I turn them on at the wall switch they go to full brightness. By default, they just go to whatever level they were at last. However, when they come on via Alexa or an event they don't. They go to whatever dim level that event sets it to...
What I want to do in a way is to program a "double tap" type scenario.
If the switch turns on... then off...then on in 3-5 seconds set the dim to 98.
I just started using the interface yesterday and guessing this is easy...but have not quite got it yet. Any help would really be appreciated. THANKS!
I have older GE/Jasco wall switches and would like that when I turn them on at the wall switch they go to full brightness. By default, they just go to whatever level they were at last. However, when they come on via Alexa or an event they don't. They go to whatever dim level that event sets it to...
What I want to do in a way is to program a "double tap" type scenario.
If the switch turns on... then off...then on in 3-5 seconds set the dim to 98.
I just started using the interface yesterday and guessing this is easy...but have not quite got it yet. Any help would really be appreciated. THANKS!