I am trying to have this scenario play out...
when we come home at night, ramp up the outside lights to 100%.
after 10 minutes ramp them back down to where they where before, which is typically dimmed to some amount, but sometimes they are off.
I use the aeotec micro dimmers, and my programming is:
Set Device 'light' to ON (this works fine)
...
then Wait 10 Minutes (this works fine)
...
Then Set Device 'light' to Last. (does nothing)
I am assuming Last will go to the level just before the last change. So if they were 'off' then changed to 50%, and then you send the last command it should go to 'off', correct?
Am I wrong in understanding how this works?
Thanks!
when we come home at night, ramp up the outside lights to 100%.
after 10 minutes ramp them back down to where they where before, which is typically dimmed to some amount, but sometimes they are off.
I use the aeotec micro dimmers, and my programming is:
Set Device 'light' to ON (this works fine)
...
then Wait 10 Minutes (this works fine)
...
Then Set Device 'light' to Last. (does nothing)
I am assuming Last will go to the level just before the last change. So if they were 'off' then changed to 50%, and then you send the last command it should go to 'off', correct?
Am I wrong in understanding how this works?
Thanks!
Comment