I purchased a Besense 360 Ceiling Motion Sensor. This is a Z-wave Plus device. I was able to add it to my network. Homeseer shows
Add Node started...
Activate the 'Add to Network' function on the device...
A new node is being added...
Adding a new SLAVE NODE...
DONE - Add Node Operation is Complete.
Done. Node 34 Added.
Reloading (importing) node information...
Synchronizing node information with HomeSeer and creating new device(s) as necessary...
Synchronize nodes finished. Number of device nodes to be created/added = 1
Z-Wave manufacturer information for node 34, ID: 532=214H (UNKNOWN), Type: 3=3H, ID: 2=2H
Node: 34 Supports Class(es): ZWAVEPLUS_INFO, SENSOR_BINARY_V2, WAKE_UP, BATTERY, VERSION_V2, MANUFACTURER_SPECIFIC_V2, NOTIFICATION_V6, CONFIGURATION, ASSOCIATION, ASSOCIATION_GRP_INFO, POWERLEVEL, DEVICE_RESET_LOCALLY
Node 34 is a Z-Wave Plus node. Retrieving ZWPlus Info...
Error: Node 34 did not provide Wake-Up Command Class information - it will not be processed further.
Warning: The device at node 34 should result in 3 child devices being created, but the node interrogation currently has 0. This may still result in a successful child creation.
Finished.
Saving network information to file: ZNet_Home_ED2D1118_2019-01-20_19.20.56.ZWave. Please wait...
Done!
Anyone have luck using this sensor with Homeseer?
Add Node started...
Activate the 'Add to Network' function on the device...
A new node is being added...
Adding a new SLAVE NODE...
DONE - Add Node Operation is Complete.
Done. Node 34 Added.
Reloading (importing) node information...
Synchronizing node information with HomeSeer and creating new device(s) as necessary...
Synchronize nodes finished. Number of device nodes to be created/added = 1
Z-Wave manufacturer information for node 34, ID: 532=214H (UNKNOWN), Type: 3=3H, ID: 2=2H
Node: 34 Supports Class(es): ZWAVEPLUS_INFO, SENSOR_BINARY_V2, WAKE_UP, BATTERY, VERSION_V2, MANUFACTURER_SPECIFIC_V2, NOTIFICATION_V6, CONFIGURATION, ASSOCIATION, ASSOCIATION_GRP_INFO, POWERLEVEL, DEVICE_RESET_LOCALLY
Node 34 is a Z-Wave Plus node. Retrieving ZWPlus Info...
Error: Node 34 did not provide Wake-Up Command Class information - it will not be processed further.
Warning: The device at node 34 should result in 3 child devices being created, but the node interrogation currently has 0. This may still result in a successful child creation.
Finished.
Saving network information to file: ZNet_Home_ED2D1118_2019-01-20_19.20.56.ZWave. Please wait...
Done!
Anyone have luck using this sensor with Homeseer?
Comment