I have a relatively small Z-Wave network with a couple of powered devices (QTY 2 - HomeSeer HSM200 Z-Wave Multi-Sensors) and 3 battery operated Yale Door Locks. I setup the locks by bringing my Z-Net controller right next to door locks and then when the lock setup is complete, I put the Z-Net controller back in its usual place. I am seeing that the Garage Yale lock misses commands every now and then (it is the furthest device from the Z-Net controller). If I were to add a new powered HomeSeer HSM200 Z-Wave Multi-Sensor between the Z-Net controller and the battery operated garage Yale Door Lock, does anything special need to be done for the HSM200 Z-Wave Multi-Sensor to relay commands to and from the door lock? Any kind of optimization given that the Yale lock is battery powered?
Thanks!
Thanks!
Comment