How to send X10 house and unit code only - Solved!

[Rupp]

Guys,
I'm helping a friend install some switch lincs and he wants X10 codes programed as part of the install. The problem is I'm not sure how to do this any longer. In the old HS2 days there was an option to do this via the Control Panel. Any ideas are welcomed.

[Eman]

Guys,
I'm helping a friend install some switch lincs and he wants X10 codes programed as part of the install. The problem is I'm not sure how to do this any longer. In the old HS2 days there was an option to do this via the Control Panel. Any ideas are welcomed.

The codes are set on the modules themselves and depending on what type interface you are using RFXCom / CM15 Pro setup may defer but read through these documents : https://www.domoticz.com/wiki/X10_devices,_CM15_Pro , https://www.uk-automation.co.uk/cont...er%20Guide.pdf for clues. Note : Windows may defer from Linux.

Extra : https://www.youtube.com/results?sear...+modules+setup



Eman.

[Uncle Michael]

You can use a short script.
https://forums.homeseer.com/forum/li...-from-a-script

[Rupp]

Thanks Mike. I was coming back here to say I had found that script but it turns out that I could send the entire code ie F7 On from an event to program these. Thanks for responses guys. X10 lives on