I just installed an Aeotec Heavy Duty Switch and can't get it to auto-report changes in Watts (or % changes). I have an Aeotec Smart Switch 6 the auto-reports Wattage chagnes just fine.
Devices created when added to network:
--Root Node
--Switch control
--Amperes
--kW Hours
--Volts
--Watts
Here's what I've tried:
1) Added to Z-wave network. The first time I got the security warning/error. Removed and re-added--worked fine the second time.
2) It is reporting kWh, W, and A on the time-bases that specified in the Root Device's Z-Wave settings.
3) See screen-shot of the Z-Wave settings page (attached). The 65460 setting for "how often the data is automatically sent" is copied from my Smart Switch 6 settings. I only want it to report when the Watts changes. If I change that value to 30, it does report every 30 seconds.
4) Manually set the configuration parameters (in the following order), using the "Set Configuration Parameters" in the Settings section.
-Set Parameter 101 to 12 [4-bytes] (kWh & Watt)
-Set Parameter 91 to 10 [2-bytes] (Watts)
-Set Parameter 92 to 5 [1-bytes] (Percent)
-Set Parameter 90 to 1 [1-bytes] (Enable change reporting)
5) Disconnected power, waited 15 seconds, reconnected power to the device. Is still reports at set interval, but still doesn't report on Wattage changes.
Any ideas anyone??
Thanks,
--Doug
Devices created when added to network:
--Root Node
--Switch control
--Amperes
--kW Hours
--Volts
--Watts
Here's what I've tried:
1) Added to Z-wave network. The first time I got the security warning/error. Removed and re-added--worked fine the second time.
2) It is reporting kWh, W, and A on the time-bases that specified in the Root Device's Z-Wave settings.
3) See screen-shot of the Z-Wave settings page (attached). The 65460 setting for "how often the data is automatically sent" is copied from my Smart Switch 6 settings. I only want it to report when the Watts changes. If I change that value to 30, it does report every 30 seconds.
4) Manually set the configuration parameters (in the following order), using the "Set Configuration Parameters" in the Settings section.
-Set Parameter 101 to 12 [4-bytes] (kWh & Watt)
-Set Parameter 91 to 10 [2-bytes] (Watts)
-Set Parameter 92 to 5 [1-bytes] (Percent)
-Set Parameter 90 to 1 [1-bytes] (Enable change reporting)
5) Disconnected power, waited 15 seconds, reconnected power to the device. Is still reports at set interval, but still doesn't report on Wattage changes.
Any ideas anyone??
Thanks,
--Doug
Comment