Announcement

Collapse
No announcement yet.

Monoprice 115902 Z-Wave Sensor

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Monoprice 115902 Z-Wave Sensor

    I bought one of the Monoprice 115902 Z-Wave Home Automation sensors and cannot get it to include in my network. Any ideas?
    Kirk

    http://cleverhouseautomation.ca
    http://southcoastwebsitedesign.ca

    #2
    I've got half a dozen or more in service. Make sure you're not pressing the tamper switch to try to include. The correct switch is recessed and requires a pin or paper clip to start inclusion.


    Sent from my Pixel 2 using Tapatalk

    Comment


      #3
      Yes, I originally was using the tamper. Looked online to how to include and am now using a paperclip. However it did not change. I even bring the unit right next to the controller and still no luck. Very frustrating because I have never had an issue including any device.
      Kirk

      http://cleverhouseautomation.ca
      http://southcoastwebsitedesign.ca

      Comment


        #4
        Did you remove it from the network first?
        HS4Pro on a Raspberry Pi4
        54 Z-Wave Nodes / 21 Zigbee Devices / 108 Events / 767 Devices
        Plugins: Z-Wave / Zigbee Plus / EasyTrigger / AK Weather / OMNI

        HSTouch Clients: 1 Android

        Comment


          #5
          Yes I have added and removed many times. I have even removed, re optimized the network, restated the whole computer and then tried to include again. Only the status child get added. I think maybe once or twice the battery child was added as well. Never motion, humidity or anything else/
          Kirk

          http://cleverhouseautomation.ca
          http://southcoastwebsitedesign.ca

          Comment


            #6
            Did you try adding it to the network unsecured? I cant readily tell from the specs if it is a secure device or not...
            HS4Pro on a Raspberry Pi4
            54 Z-Wave Nodes / 21 Zigbee Devices / 108 Events / 767 Devices
            Plugins: Z-Wave / Zigbee Plus / EasyTrigger / AK Weather / OMNI

            HSTouch Clients: 1 Android

            Comment


              #7
              These are rebadged zooz sensors.
              In the monoprice comments someone mentions
              "The trick for me was to use the reset button on the bottom of the unit instead of the program button inside."

              this is the link to the v2 manual https://www.getzooz.com/downloads/zo...er2-manual.pdf

              Comment


                #8
                I had fits trying to get mine to work also. I did get it to include unsecured, but no child devices were created. One time I did a "Rescan" and unintentionally left it overnight. When I got up the next morning, the rescan had worked, and all the child devices were there. Has been working fine ever since.
                My system is described in my profile.

                Comment


                  #9
                  I have the Zooz Version and been VERY happy with them so far. They seem much faster than the Aeon 5-in-1 with much better battery life.
                  For me, I used the supplied paper clip through the hole in the bottom. One weird thing I noticed is that I had to have the battery cover ON the sensor when including or doing a rescan. I always included them first, right at the z-net and then once I got them to their new location did a rescan and optimize.

                  Comment

                  Working...
                  X