According to the manual https://homeseer.com/wp-content/uplo...S-MS100v1b.pdf
This sensors should act as a repeater. So why I am having this notification into the z wave device utility page ? There are no batteries into the device.
''Note: The device must be woken up manually to use the functions below.''
Important: Line-powered devices function as Z-Wave repeaters. If you’ll be powering HS-MS100+ with batteries, include it into your network ON BATTERY POWER to prevent it from repeating Z-Wave commands. This functionality would quickly deplete your Motion Sensor’s batterie
''Note: The device must be woken up manually to use the functions below.''