I have a “hasseman” (brand) zwave DIN rail 6 way switch.
it installs and creates various devices - all ok, i can control all the switches - ok.
im aware it also has 1wire temp sensor capability.
however when creating devices - there i NO device created for the temp sensor & im getting an error in HS log (multiple times every 30 secs)
I can seuccesfully exclude, and then do a new inclusion - with same devices again created, but no temp sensor device.
below is the HS3 error message. which indicates to me that the znet interface is reciving a zwave messsage - destined for a device that doesnt exist.
but i have no way of creating? this device manually.
The switch is node 59 (& other devices created are all slaves under the node 59 root device .. but there is no 59-1 (or similar) device
The hasseman din rail switch has a very perfunctory “manual” - with NO details on associations or zwave parameters... so im in the dark.
Ive also tried disconnecting 1wire sensor, which has no effect on this behaviour.
hoping someone may have an insight into config for this device, or how to manually work around.
(i dont really want the temp sensor data/device - but this is jamming up my znet controller and system with constant messages)
it installs and creates various devices - all ok, i can control all the switches - ok.
im aware it also has 1wire temp sensor capability.
however when creating devices - there i NO device created for the temp sensor & im getting an error in HS log (multiple times every 30 secs)
I can seuccesfully exclude, and then do a new inclusion - with same devices again created, but no temp sensor device.
below is the HS3 error message. which indicates to me that the znet interface is reciving a zwave messsage - destined for a device that doesnt exist.
but i have no way of creating? this device manually.
| 11 3:26:29 PM | Z-Wave Error | (2) Sensor Multilevel Report for type Air_Temperature received, but the corresponding device Node ID cannot be found.(2) Node/Instance=59/-1 | ||||||||||
| Apr-11 3:26:29 PM | Z-Wave Error | (2) Sensor Multilevel Report for type Air_Temperature received, but the corresponding device Node ID cannot be found.(2) Node/Instance=59/-1 | ||||||||||
The hasseman din rail switch has a very perfunctory “manual” - with NO details on associations or zwave parameters... so im in the dark.
Ive also tried disconnecting 1wire sensor, which has no effect on this behaviour.
hoping someone may have an insight into config for this device, or how to manually work around.
(i dont really want the temp sensor data/device - but this is jamming up my znet controller and system with constant messages)