Factory Reset Wayne Dalton Outdoor Plugs

[ViperJD]

I have a few HA-04 Wayne Dalton Outdoor Plugs. I can't figure out what node they are (seems like what I wrote on them was wrong or no longer works) or if they are working. Any way to find what Node they are or to maybe Factory Reset them and add them again?

[rmasonjr]

You should be able to just do an exclude and that will make them ready to include again...

[ViperJD]

\\

You should be able to just do an exclude and that will make them ready to include again...

When I try to Exclude them, I get the
"Please wait...
Activate the 'Remove from Network' function on the device..."

I click the On/Off button, but nothing. Tried it on all of them.

[rmasonjr]

The exclude/include function might be holding the switch down for several seconds.

[ViperJD]

The exclude/include function might be holding the switch down for several seconds.

Thanks, but it did not seem to make a difference. The manual on off works, but these are old and maybe just no good anymore.

[rmasonjr]

That stinks I have the intermatic version of this switch, but it's been running fine for a number of years.

[Guest]

Have you tried (temporarily) moving the plug to be near the ZWave hub when doing the Exclude?