Announcement

Collapse
No announcement yet.

Z-Wave devices showing up as "battery" when they're hard-wired

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Z-Wave devices showing up as "battery" when they're hard-wired

    This seems to happen off an on. A device that is clearly hard-wired shows up as battery - not a new device... it's like it changed somehow. It's only detectable in Z-Seer+ or by going into the device's Z-Wave tab to see the "Note: The device must be woken up manually to use the functions below." message.

    Only fix I've found is to delete the device and replace it. Any better solutions?

    Attached Files

    #2
    One of these just popped up for me in z-seer -- also a HS-WD200 device. Rescanning the device didn't get rid of that battery indicator. Weird. Any traction on this?

    Comment


      #3
      Did both of you guys put in support tickets on this issue?
      https://dev.homeseer.com/servicedesk/customer/portal/2
      -Rupp
      sigpic

      Comment


        #4
        I have seen this as well

        Comment


          #5
          FTR, I submitted a ticket way back... no response. No surprise. I just tolerate it. We'll see if it comes back in HS4.

          Comment

          Working...
          X