Zwave Monitor?

[avpman]

Is there a way to watch ZWave traffic on a Zee II? For example, if I double-tap a defined paddle can I see that the Ztroller received the command from the switch?

Thanks!

[randy]

Is there a way to watch ZWave traffic on a Zee II? For example, if I double-tap a defined paddle can I see that the Ztroller received the command from the switch?

Thanks!

I don't know any way to see if a controller received a command, but all received commands are logged in HomeSeer's log. If it doesn't make it to the log, then it is unlikely the controller received it.

[rmasonjr]

At one time, you could put the Z-Wave plugin in debugmode:
&hs.DebugMode = 64

I'm not sure if this still works in the recent versions of HS.

[avpman]

At one time, you could put the Z-Wave plugin in debugmode:
&hs.DebugMode = 64

I'm not sure if this still works in the recent versions of HS.

Thanks! What is "&hs.DebugMode = 64" and where do I enter that?
Much appreciated!

[rmasonjr]

It's an immediate script command - for HS4, click Tools -> Script Commands

[jon00]

Thanks! What is "&hs.DebugMode = 64" and where do I enter that?
Much appreciated!

To turn it off again use hs.DebugMode = 0

Details of all debug codes are shown below.

[jon00]

At one time, you could put the Z-Wave plugin in debugmode:
&hs.DebugMode = 64

I'm not sure if this still works in the recent versions of HS.

I think that was HS2 only:

https://homeseer.com/support/homesee..._debugmode.htm

[enigmatheatre]

If you go to Plugins/Z-Wave/Config in the plugin choices in HS4 or click on the plugin name in HS3 then you have the option to Log send and receive device information to the HomeSeer log. This might help you see what you are looking for.