I just got a bunch of toys in the mail including the CM11A and a bunch of LampLincs. I'm trying to program the LampLinc with no luck. I have confirmed that the CM11A works properly by turning on/off my old X10 lamp devices.
To program the new LampLincs, I:
- hold the button next to the LED for 5 seconds until it is blinking
- open the X10 control panel in HomeSeer, enter "C3" and hit "address only"
Nothing happens. According to the manual I'm expecting the lamp to flash. Am I doing something completely wrong? Any help appreciated.
thanks,
dan
To program the new LampLincs, I:
- hold the button next to the LED for 5 seconds until it is blinking
- open the X10 control panel in HomeSeer, enter "C3" and hit "address only"
Nothing happens. According to the manual I'm expecting the lamp to flash. Am I doing something completely wrong? Any help appreciated.
thanks,
dan
Comment