I have the z-wave Fibaro Motion and Temp Sensor(FGMS-001). It has a large number of parameters that must be set in my application of the sensor. I read somewhere on this Forum that someone had been using a manual Event with many "Actions", each setting a single parameter. My question is if I have ~10 "Actions", each setting one parameter, do I need a delay between each and will the Fibaro unit stay awake or do I need to keep re-awakening it during the Event execution. Any insights would be appreciated.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Comment