kenm
It is documented here under the mcsMQTT sub forum going back to year before last...
SonOff basic WiFi seeing Sensors with mcsMQTT
I maxed it to 5 1-wire temperature sensors to one Sonoff basic. Thinking you can do more. I put one 1-wire sensor on my multifunction GDO SonOff basic and one 1-Wire sensor on each of the modded magic home controllers for my kitchen LED lighting.
Before this and after the TempXX stuff went to using RPi OWFS servers hard wired to the 1-Wire network. It would be great to be able to just add the entire OWFS library to an Ardunio / Wifi basic device. Maybe someday. I think there is a OWFS to MQTT plug someplace out there in internetlandia.
Same devices that connect to Homeseer via mcsMQTT also connect to Home Assistant.
Note this is only for Temperature and Humidity sensors. The Omnistat thermostat below is serially connected to the OmniPro panel which is seen by Homeseer / Omni plugin and Home Assistant Omnilinkbridge plugin. Some of the temperature / humidity sensors below are connected to the OmniPro 2 panel. I keep adding sensors. Attic down to the second floor and basement up to the first floor and outside.
Thinking I started to play with the 1-Wire sensors in the 1990's so other than X10 (started in the late 70's) 1-Wire stuff is really old now.
It is documented here under the mcsMQTT sub forum going back to year before last...
SonOff basic WiFi seeing Sensors with mcsMQTT
I maxed it to 5 1-wire temperature sensors to one Sonoff basic. Thinking you can do more. I put one 1-wire sensor on my multifunction GDO SonOff basic and one 1-Wire sensor on each of the modded magic home controllers for my kitchen LED lighting.
Before this and after the TempXX stuff went to using RPi OWFS servers hard wired to the 1-Wire network. It would be great to be able to just add the entire OWFS library to an Ardunio / Wifi basic device. Maybe someday. I think there is a OWFS to MQTT plug someplace out there in internetlandia.
Same devices that connect to Homeseer via mcsMQTT also connect to Home Assistant.
Note this is only for Temperature and Humidity sensors. The Omnistat thermostat below is serially connected to the OmniPro panel which is seen by Homeseer / Omni plugin and Home Assistant Omnilinkbridge plugin. Some of the temperature / humidity sensors below are connected to the OmniPro 2 panel. I keep adding sensors. Attic down to the second floor and basement up to the first floor and outside.
Thinking I started to play with the 1-Wire sensors in the 1990's so other than X10 (started in the late 70's) 1-Wire stuff is really old now.
Comment