I am trying to find the parameter set for the Jasco smart dimmer switch ZW3010. I've looked on line and have only found a few parameters none of which seem to have an effect. Specifically I am looking for the parameter to cause the light to go on/off instantly (no dimming ramp) when commanded from another switch in the association group. I was able to get this behavior for local control at the switch and for zwave commanded on/off commands. Any suggestions?
Announcement
Collapse
No announcement yet.
Jasco ZW3010 Parameter set
Collapse
X
-
Greetings from a near taiello6683,
Do you have these from the Z-WaveAlliance.org?
Hope it helps,
Roger D
-
On my older Z-Wave GE/Jasco dimmers (45606, 45612) the dimming parameters are 7 and 8 (Z-Wave dim), 9, and 10 (rocker dim), and 11 and 12 (All-On/Off command). The lower parameter is the number of steps, the upper one is timing of the steps. I always set all of these to 1 to get the fastest dimming possible.
Comment
Comment