Announcement

Collapse
No announcement yet.

Replase insteon interface

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Replase insteon interface

    Hi Mark
    I'd like to use a separate Insteon PLM and not the hub anymore.Under swap interface you have input old ID.Should I input the old hub ID there and will I get a prompt for the new interface ID Later.
    Also the warning:
    CAUTION: This function assumes that you replaced the Insteon computer interface on your system with a new one. Since each device has its own unique address that is encoded into every Insteon device that it communicates with, all of the devices that used to communicate with the old interface can no longer communicate with the new one without reprogramming. This function will reprogram all the remote devices with the new interface address for you. Make sure all your Insteon devices are available for programming. This process cannot be undone. This process may take a considerable amount of time to complete depending on the number of devices that are linked to the original interface. Please check the final screen for any errors or messages. You may run this again if necessary.
    Do I need to manually input all insteon switch IDs again?
    Thanks, Michael
Working...
X