Sigma Notification Sensor 🤦‍♂️

[jbfoster]

I keep deleting these but every now and then they come back. They look to be some old devices that were removed. Is there a way to delete so they don't keep coming back?

Thanks
Jim

[Rupp]

Try going to the Z-Wave tab on these devices and use the remove failed node option and see if this removes them from your Z-Wave controller.

[jbfoster]

Try going to the Z-Wave tab on these devices and use the remove failed node option and see if this removes them from your Z-Wave controller.

Didn't work.

[BobSpen]

Be sure to run "Test Connectivity"(and it will fail) BEFORE you run "Remove Bad Node" on EACH device that you want to remove.

[jbfoster]

Be sure to run "Test Connectivity"(and it will fail) BEFORE you run "Remove Bad Node" on EACH device that you want to remove.

Thanks that did the trick. I was able to remove all but one. The last one keeps failing to remove.

Thanks
Jim