After including a (Jasco) GE Enbrighten Smart Motion Switch, I get a root device with 2 features created. One is the switch which works correctly and the other is "Notification" which I am assuming is the motion sensor but it doesn't appear to be created correctly. I have excluded / included a couple of times and re-scanned but no luck. The log looks normal EXCEPT for this error during creation
9/14/2022 6:43:24 PM
Legacy-Plugin
Z-Wave Warning
Node 5 did not respond to the Notification Supported request.
And this error when moving in front of the sensor.
9/14/2022 6:54:12 PM
Legacy-Plugin
Z-Wave Error
Notification Report from node 5 for type Home Security received, but the corresponding device Node ID cannot be found. (2, Type=7)
I've uploaded my pictures of the device page and the feature page. Does anyone have one that was created successfully and can provide the correct Status/Graphics parameters
Thanks
Jeff
Comment