Can anyone point me at a z-wave plug that senses & reports a plugged in device's on/off status? For example, if I have light plugged into the plug, I would be able to tell if the light is on or off. I don't necessarily want to be able to turn the plug on or off, just get the status of the device plugged into it.
Announcement
Collapse
No announcement yet.
Smart Plug
Collapse
X
-
You'll want something like this:
https://a.co/d/0Y5ek61
It will have current monitoring, so if you see watts > 0 then the light is on.
HS4Pro on a Raspberry Pi4
54 Z-Wave Nodes / 21 Zigbee Devices / 108 Events / 767 Devices
Plugins: Z-Wave / Zigbee Plus / EasyTrigger / AK Weather / OMNI
HSTouch Clients: 1 Android
-
Originally posted by randman View PostI just got a ZEN04 with firmware 1.20. The Volts device doesn't update. It remains 0 volts. The other devices (kW Hours, Watts, Amperes) update just fine. Any reason why Volts isn't updating for mine? I have the ZEN15, and its Volts device updates fine. But not for my ZEN04.
Comment
-
Originally posted by Coz View Post
The voltage on all of mine are updating. I've attached a screenshot of the info for one of them but I'm still on 1.10.
Comment
-
I think I originally added them in secure mode then uninstalled and added them back as non secure. I don't know if secure mode caused a problem with these devices but it did with my ZSE40 700. After my issue with the ZSE40 700's I removed and reinstalled most of my devices that were in secure mode to non secure mode.
Comment
-
Originally posted by will40 View PostThis may not be applicable but I had a similar problem with my AEON Labs Smart Switch 6. It reported everything but voltage. Once I set the Volts child device to poll every 5 mins the voltage started reporting and ever since. Hope this helps
Comment
-
Originally posted by randman View PostI excluded the ZEN04. I added it back in using non-secure mode. Didn't help. I still get 0 for Volts. Polling doesn't help either.
Comment
-
I updated this morning to 1.20 and still have a voltage reading. I uninstalled the device and re added it and still have a voltage reading. I don't know how valid my test is since the device was already installed and working with 1.10 before I upgraded the firmware.
You will need to open a case with zooz after you register your device and ask to get the 1.10 firmware. It is not something they have listed. I let zooz know what I was doing and asked for 1.10 just in case something went south. I was told they will get it to me, but at this point... I don't need it.
Comment
Comment