Dragon Tech PA-100

[outbackrob]

I bought a ton of these over the years. They work great. Had one die over 2 years ago, but the rest are (or were) in working order. Today, TWO stopped working. Both are flashing the power button. Neither respond to z-wave commands, nor do they respond to z-wave parameters. Anyone else run into this? If so, is there a fix? I could replace them with WiFi modules, but I am attached to them!

[wpiman]

The manual says that have an internal resettable fuse.

-Internal resettable fuse to protect from surge current

https://fccid.io/2ABWCPA100/User-Man...al-2333697.pdf

Do you have a whole house surge protector?

[kenm]

Try unplugging them for about 30 mins and then re-plug. I recovered a couple this way a few years back.

[outbackrob]

THANKS, GUYS! That gives me some hope. Found TWO MORE today. We had a serious lightning storm that may have been the cause. ....though we have had FAR WORSE storms without any issue. .....and no, I do not have a whole house surge protector. Yet.

THANKS again!!

[wpiman]

THANKS, GUYS! That gives me some hope. Found TWO MORE today. We had a serious lightning storm that may have been the cause. ....though we have had FAR WORSE storms without any issue. .....and no, I do not have a whole house surge protector. Yet.

THANKS again!!

I installed a whole house surge protector myself. Took about 2 minutes and was like $100 at the time.