-
Hello, I have a problem with creating an event. To reduce my amount of events I tried to make one that starts at a certain time with turning a device light on. Then after several hours it should turn that light of. Now I have to make 2 events, one turning the light on, second turning the light of. The event above starts at 6.35 but doesn't end at 07:30. What am i doing wrong.
-
I am sorry. I have posted this message in the wrong topic. Should in event clinic been posted -
The second part of your event would imply that it is 6:35 and 7:30 at the same time.
You either have to change the main trigger, add a "after waiting for" to the second part, or split in 2 events.HS4, HSTouch Designer, ESP based devices and sensors, Tasmota, OpenMQTTGateway, RTL433, DIY ground plane antenna, BlueIris + LAN cams, USB-UIRT, ATON DLA amp, WACUP, Multiple Android tablets for control.
Plug-Ins Enabled: Restart:,EnvCan:,EasyTrigger:,CM15A:,BLUSBUIRT:, BLLAN:,BLBackup:,Pushover 3P:,mcsMQTT + multiple Jon00 toolsComment
-
Thank you@123qweasd. That did the trick. I am not sure of using two events or add after waiting for. Thanks again.Comment
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Comment