Announcement

Collapse
No announcement yet.

HSM200 Repeating Motion

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • grtaylor
    replied
    I have this issue now with two of my three devices. A power cycle does not seem to help.

    They time out and send No Motion, then immediately send Motion again.

    Any new advice? This is annoying.

    Leave a comment:


  • andyf
    replied
    I have the issue with one of my HSM200s. It gets into a state where it sends a motion detect immediately after a no motion. A power cycle restores normal operation. I assume signs of a dying motion sensor.

    Leave a comment:


  • Buddy
    started a topic HSM200 Repeating Motion

    HSM200 Repeating Motion

    Recently I been having problems with two of my Z-wave Multi-sensors HSM200, when it sees motion it keeps on repeating the event trigger every minute (off delay setting) even after leavening the room, if I remotely turn the light off it turns right back on. In the device list for the monitor sensor the icon is always showing motion. I have to unplug it for a minute or so then it will operate properly and then I can turn the light off. This happens periodically and it seems to have started after I updated to version 4.2.18.3. I checked to log and the only thing was the sensor login motion no errors.





    I have two controls one HS4 Pi and a HS Troller Plus and it is happening on both.
    ‚Äč
Working...
X