I have an HS-WD200+ that I have set up to turn on (Scene 001) or off (Scene 002) some zigbee lights. This has been set up as events that are triggered by the paddle presses. The lights that are controlled by HS-WD200+ directly respond instantaneously. However, the zigbee lights take several seconds to turn on or turn off. On the other hand, a Zooz Z-wave switch that is programmed similarly results in an instantaneous response from the zigbee lights. The Zooz switch is within a few feet of the HS-WD200+. It's not a big deal, but I would be curious if there may be a way to shorten the time lag for the HS-WD200+ triggered events. Troubleshooting suggestions would be appreciated. Thanks.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.