I keep on having troubles with our Bali shades (z-wave). I have an event that closes a particular shade to 7% (which is the percentage where the "slates" are closed). Just a little while ago the event did run and the shade moved but stopped at 87%. Because I keep having similar issues with other Bali shades I now send to commands spaced apart by 30s. Hence the event shown below. That's the event that ran and moved the shade.
So since the shade didn't go to 7% I did go to our HS portal and manually triggered the event. In the log I can see that the event was triggered and did try to set the shade to 7%. But then you also see a report that the shade is at 87%. And the shade didn't even try to budge. So I guess it either didn't get a signal to move or it thought it is already at 7% while it's actually at 87%.
When I go to the device there is a slider to set the percentage which is at 87%. When I move the slider to the left it jumps back to 87% after about 1s and the shade doesn't move.
Clicking on the on/off button does move the shade so the shade is working.
So since the shade didn't go to 7% I did go to our HS portal and manually triggered the event. In the log I can see that the event was triggered and did try to set the shade to 7%. But then you also see a report that the shade is at 87%. And the shade didn't even try to budge. So I guess it either didn't get a signal to move or it thought it is already at 7% while it's actually at 87%.
When I go to the device there is a slider to set the percentage which is at 87%. When I move the slider to the left it jumps back to 87% after about 1s and the shade doesn't move.
Clicking on the on/off button does move the shade so the shade is working.