Just purchased a Powerflash module and am attempting to set it up as a dry-contact sensor to a magnetic door switch. I have set the Powerflash code to E1. For testing, I also setup a lamp module to E1. The magnetic contact closure turns the light on as expected.
I have the Powerflash module setup in HS 2.0 as a chime module as E1 and the lamp module (setup as lamp module) on E1 as well.
The problem is, while opening / closing the mag contact turns the light on and off properly, nothing is logged in the HS log reflecting this. However from HS, I can manually trigger the light on / off so I know HS can communicate with the module.
Can anyone see where I might be goofing up here?
The Powerflash is set to "Mode B" (dry contact) and is physically 10 feet from my HS PC on the same circuit.
Thanks for any help,
Bill
I have the Powerflash module setup in HS 2.0 as a chime module as E1 and the lamp module (setup as lamp module) on E1 as well.
The problem is, while opening / closing the mag contact turns the light on and off properly, nothing is logged in the HS log reflecting this. However from HS, I can manually trigger the light on / off so I know HS can communicate with the module.
Can anyone see where I might be goofing up here?
The Powerflash is set to "Mode B" (dry contact) and is physically 10 feet from my HS PC on the same circuit.
Thanks for any help,
Bill