If this is your first visit, be sure to check out the FAQ. You must register before you can post. Your first post will be checked for appropriate content
(SPAM) - please allow a bit of time for that. After that, you'll be able to post at will!
I took a look at the RUSSOUND DPA-4.8 documentation. These comments are based on a brief look at manuals.
The DPA-4.8 itself does not have anything to control remotely. It looks like all control is done through a pre-amp like the PR-4Zi. So, I looked at the preamp documentation. The serial communication protocol looks very straightforward (it only takes 2 pages in the manual to explain it and it explains it pretty well). You should be able to control the pre-amp using simple serial commands in HS scripts.
I have no personal experience with these, but it doesn't look like it would be difficult at all.
Comment