Greetings all,
I've been noticing some weird things that I can't figure out.
When I DIM a device through HS on the device control screen, it reports the DIM status for a moment, and then it shows the device as OFF.
The device reacts correctly, but HS is seeing some kind of signal that makes it think the device has been turned off.
I can get a similar weird thing if I check the status of a device. EX: I have two lights in my office, an overhead light and some can lights. If I do a status check on Cans, it will report the correct status and then change the Overhead light status to off. If I check Overhead, it will report the right status and then change the Cans status to off.
The lights themselves don't react, its just what's being reported in HS that is wrong.
Any ideas?
Steve C.
I've been noticing some weird things that I can't figure out.
When I DIM a device through HS on the device control screen, it reports the DIM status for a moment, and then it shows the device as OFF.
The device reacts correctly, but HS is seeing some kind of signal that makes it think the device has been turned off.
I can get a similar weird thing if I check the status of a device. EX: I have two lights in my office, an overhead light and some can lights. If I do a status check on Cans, it will report the correct status and then change the Overhead light status to off. If I check Overhead, it will report the right status and then change the Cans status to off.
The lights themselves don't react, its just what's being reported in HS that is wrong.
Any ideas?
Steve C.