What do I need?

[Jim'll]

I have just recieved a couple of x10 cameras with the multiview software.
what do i need to tie this in with homeseer?
is it the cam pluginn
also is it possible to control the Pan & Tilt camera mount via homeseer?
thanks
Jim

[independentpete]

The WebCam Plug-In is one way to do it. I don't use those cameras or that plug-in, so I can't comment too much on them. ...Don't want to steer you in the wrong direction.

As for Pan & Tilt, if you mean the Ninja base, there are a few threads on this board that discuss controlling it with HS. Yes, it's possible. Just do a search. This thread will get you started...
http://ubb.homeseer.com/eve/ubb.x?a=...224#3166014224

[Jim'll]

Thank you for that
I have instaled the plugin and created a device for the ninja but nothing is happening?
I didn't understand this part of the instal:-
2) Register the ocx at a command line:
regsvr32 hspi_CM19A_USB.ocx
Where and what is a command line?
thanks jim

[independentpete]

jamesclabon: I'm flying blindly here... Like I said, I don't have/use that plug-in, but...

Command line: Get to the command line by going to Start --> Run and typing cmd at the Open field. This will launch the command prompt. Then, at the promt, you'll type the command as instructed... regsvr32 hspi_CM19A_USB.ocx. This will register the plug-in.