I'm having a bit of a mind blank.
I have a motion sensor on the same code as a lamp module (they are on the same code as I want quick response). I have a W800 which acts as the RF interface into homeseer.
The setup at the moment is that the On / Off signals from the Motion sensor turns the light on off. I want to configure it such that the on signal from the motion sensor turns it off but Homeseer controls the turn off. I know with the W800 I can get it to supress the off signals but what I cant figure out is how to configure homeseer.
Any ideas ??
Thanks
I have a motion sensor on the same code as a lamp module (they are on the same code as I want quick response). I have a W800 which acts as the RF interface into homeseer.
The setup at the moment is that the On / Off signals from the Motion sensor turns the light on off. I want to configure it such that the on signal from the motion sensor turns it off but Homeseer controls the turn off. I know with the W800 I can get it to supress the off signals but what I cant figure out is how to configure homeseer.
Any ideas ??
Thanks
Comment