-
Guest repliedThe Powerlincs all communicate X10 over the power-line. Motion sensors broadcast X10 via RF. To receive the RF, you need a TM751 or an RR501 to put the X10 RF onto the power-line (not recommended), or a WGL W800RF32, CM19A or MR26A to put the RF directly into HomeSeer (recommended). -
Motion Sensors and Powerlinc
Powerlinc has 2 way Communications. I have an X10 Motion sensor set to M1 The powerlinc doesnt pick it up? Should it or am I doing someting Wrong?
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Leave a comment: