Question for anyone with Compose PLC CCWHISPLC

[mterry63]

I recently purchased and installed a Compose PLC celing fan controller in compatibility mode. Works great, not too terriible to setup and control.

My question is about the LEDs during operation - perhaps I missed this in the manual.

The switch has 3 speeds. It appears the LEDs will cycle through 3 "levels" one corresponding with each of the 3 speeds. However, there is always one LED which is always on, albeit in a "dim" mode. What does that signify?

Thanks for any insight.

[stevene]

That Dim led is the default speed that the switch will turn on to if tapped.

First the switch goes to full speed for 2 seconds to get the fan spinning and then will default to the speed indicated by the Dim LED.

StevenE

[mterry63]

Ah, makes sense. Great, thanks for the quick response!

[Rupp]

Ah, makes sense. Great, thanks for the quick response!

Where did you find this switch. I need one more in Ivory.

[mterry63]

Rupp, I just picked it up off ebay for $55 brand new. I'll probably never get another deal like this. I need 4 more now...