Announcement

Collapse
No announcement yet.

Setting up a remote control

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Setting up a remote control

    Hi there, I have learnt all my ir codes for all my equipment and they appear to work when i go into control on my status page. The question i have is that i would like to set up the HStouch software so do i need to make a device for every individual code or is there a way to do this whilst they are all in the remote control device.???

    Thanks in advance

    Edd

    #2
    You need a button/gadget per code.
    -Rupp
    sigpic

    Comment


      #3
      Thats what i thought, oh well a lot longer than i thought but here i go

      Comment


        #4
        Ok i have set up an individual device for a ir command and even set up an extra device to make the event for it but cant work out how to get is to sent the signal other than going into the control and clicking in there. Could someone please give me a step by step in setting this up please. I have the USBUIRT to learn the codes with itf that makes any diference

        Thanks in advance

        Comment


          #5
          You will have to use scripting. You can read about that here:
          http://board.homeseer.com/showthread.php?t=132134
          -Rupp
          sigpic

          Comment


            #6
            Well thats me knackered then as i know nothing about scripting, looks like i need to start doing alot of reading on this now

            Comment


              #7
              I don't know how your devices are set up, but lets assume a button press on your remote sends an On or Off to Homeseer. Let's call your device XYZ.

              An event to send an IR command would look something like:

              Name: whatever you like
              Trigger: Device XYZ set to status ON (or OFF as the case may be).
              Action: Send Infrared: ABC_IR (where ABC_IR is your learned IR)

              No scripting required.
              Real courage is not securing your Wi-Fi network.

              Comment


                #8
                Thank you, i will have a go

                Comment


                  #9
                  Worked a charm, thank you very much. Now for lots of setting up

                  Comment


                    #10
                    No problem. I'd advise selecting "cannot retrigger for ... seconds" on those as a debounce. One or two seconds should do.
                    Real courage is not securing your Wi-Fi network.

                    Comment


                      #11
                      Will do thanks now to work out how to make the button and associate a remote signal to it.

                      Comment

                      Working...
                      X