I'm having the toughest time with this zone controller. I bought it (two of them, actually) off the HS2 web site. It didn't work at all with the 2.2.x.x version of HS2. I started playing around with the 2.3.x.x series of betas, but they gave me all sorts of other trouble, so when 2.4 came out of beta, I was thrilled to try again.
The problem is, HS2 can't seem to 'connect' with the device. I have it added to my Z-Troller. I deleted it from the HS2 device list, then I shutdown HS2, then I restarted HS2. Then I imported devices. It shows up as a single device on the status page "ZWave Generic Controller 72". This is wrong, though, because it should also automatically add 4 button devices -- one for each of the four buttons on the device. My two other zone controllers (both VRCZ4-1LX) work just fine and have all four buttons listed correctly as devices in HS2.
When I click on the device and attempt to rescan it, I get "Node 72 did not respond, device may not operate as expected" in the HS2 log. But something is amiss because I have another device right next to it in the same 2-gang box, and that one responds immediately to a rescan request.
I want to try to debug this witih Z-Seer (I own a copy), but the 1.17 version doesn't seem to work with 2.4.0.6 (see my post here: http://board.homeseer.com/showthread.php?t=139574). Arg!!
Any help would be much appreciated.
Thank you
The problem is, HS2 can't seem to 'connect' with the device. I have it added to my Z-Troller. I deleted it from the HS2 device list, then I shutdown HS2, then I restarted HS2. Then I imported devices. It shows up as a single device on the status page "ZWave Generic Controller 72". This is wrong, though, because it should also automatically add 4 button devices -- one for each of the four buttons on the device. My two other zone controllers (both VRCZ4-1LX) work just fine and have all four buttons listed correctly as devices in HS2.
When I click on the device and attempt to rescan it, I get "Node 72 did not respond, device may not operate as expected" in the HS2 log. But something is amiss because I have another device right next to it in the same 2-gang box, and that one responds immediately to a rescan request.
I want to try to debug this witih Z-Seer (I own a copy), but the 1.17 version doesn't seem to work with 2.4.0.6 (see my post here: http://board.homeseer.com/showthread.php?t=139574). Arg!!
Any help would be much appreciated.
Thank you
Comment