I have an HM-DW001 Home Managebles Door Sensor. Works fine. Associated with Homseer, seeing On/Open/Motion and Off/Closed/No Motion just fine. It triggers events, etc, etc, etc.
But... When I lift the device away from the table/wall, and the tamper switch clicks, I get the following message in the HomeSeer log:
1/7/2010 5:16:42 PM - Warning - In Set Level for device Root Devices Door Sensor 1 which does not match command type Alarm, and its actual device could not be located - cannot continue.
It would seem like there is an "Alarm" Z-Wave response coming from this device. Which is nice. But it also seems that HS knows not what to do with said response. I have rescanned several times.
How can HS properly see and trigger from the tamper switch?
But... When I lift the device away from the table/wall, and the tamper switch clicks, I get the following message in the HomeSeer log:
1/7/2010 5:16:42 PM - Warning - In Set Level for device Root Devices Door Sensor 1 which does not match command type Alarm, and its actual device could not be located - cannot continue.
It would seem like there is an "Alarm" Z-Wave response coming from this device. Which is nice. But it also seems that HS knows not what to do with said response. I have rescanned several times.
How can HS properly see and trigger from the tamper switch?
Comment