Just bought a couple of ZW3101-WCS. These are GE branded, plug in, lamp/dimmer modules. In the doc, it says that they can be switched by load sensing (i.e. turning the lamp on/off). Specifically, the manual says:
Load Sensing
Load sensing is disabled when shipped from the factory. This
feature can be enabled if desired. Setting parameter 29 to a
value of 1 will enable the Load Sense function.
- Parameter No: 29
- Length: 1 Byte
- Valid Values = 0 or 1 (default 0)
The HS configuration page for this device doesn't show anything close... how can I set Parameter 29 with HS?
Note: This had no response after 2 days in the Z-Wave forum. I re-posted in "General Discussion". Please reply there.
Load Sensing
Load sensing is disabled when shipped from the factory. This
feature can be enabled if desired. Setting parameter 29 to a
value of 1 will enable the Load Sense function.
- Parameter No: 29
- Length: 1 Byte
- Valid Values = 0 or 1 (default 0)
The HS configuration page for this device doesn't show anything close... how can I set Parameter 29 with HS?
Note: This had no response after 2 days in the Z-Wave forum. I re-posted in "General Discussion". Please reply there.