Announcement

Collapse
No announcement yet.

2 X10 commands to make a trigger?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    2 X10 commands to make a trigger?

    Can I create a trigger by sending 2 X10 commands in near succession? I want to make a sort of "code" by sending two specific commands from a palmpad.

    Problem is that is looks like it will only use 1 X10 command at a time as a trigger.

    #2
    I do something like you are looking for, but it's script based.

    The first x10 command sets a virtual x10 device status to something that updates the last changed.

    The second x10 command fires a script that checks when the first x10 command was run and if it's within a short period of time, like less than 1 or 2 seconds, it can then take action based on both commands were pressed as a single trigger.

    Does take some tinkering. I think that's similar to how most are doing that.
    huggy_d1

    Automating made easy

    Comment


      #3
      Originally posted by aslamma View Post
      Can I create a trigger by sending 2 X10 commands in near succession? I want to make a sort of "code" by sending two specific commands from a palmpad.

      Problem is that is looks like it will only use 1 X10 command at a time as a trigger.

      I'm sure the PowerTrigger plug-in can do this.

      It has a section were you can setup X10 sequences for use on a palm pad.


      Andy

      Comment

      Working...
      X