Hi
I am new to this forum but have been using X10 for many years to control many things around the house. I have quite a large set-up with most of the automated things being controlled through a escort module in my DSC alarm panel.
I have now been looking at the next step and would like advice on which approach to take. I am leaning towards the software but the hardware does have its appeal.
If I go software can I connect direct to my XTB-IIR booster. My escort module does plug directly into this or does the PC need to be connected to a CM15 or similar. I already have a CM12U which i believe i can use.
from your experieces which would be the best approach to take.
If i go the software route I am thinking about something like the Acer Revo as the base PC to run this on.
Thanks in advance for your advice
Ken
I am new to this forum but have been using X10 for many years to control many things around the house. I have quite a large set-up with most of the automated things being controlled through a escort module in my DSC alarm panel.
I have now been looking at the next step and would like advice on which approach to take. I am leaning towards the software but the hardware does have its appeal.
If I go software can I connect direct to my XTB-IIR booster. My escort module does plug directly into this or does the PC need to be connected to a CM15 or similar. I already have a CM12U which i believe i can use.
from your experieces which would be the best approach to take.
If i go the software route I am thinking about something like the Acer Revo as the base PC to run this on.
Thanks in advance for your advice
Ken
Comment