Setting Up a GE Controller

[dumpmyster]

How do I transfer all my nodes to my GE Controller(45601) and make it a secondary controller?

[Steve Q]

Go to the "Advanced Configuration" page of the 45601 operating manual. Go to the "Copying Information to this remote" section. Follow the directions using your Homeseer z-wave interface as if it was one of the remotes.

I used this to set up 45601 as the secondary controller for my z-stick (Aeon).

Steve Q

[dumpmyster]

Ok..I was able to add all my nodes from my Z-Troller to my GE controller.. TY..But now how do I assign a button to each of my lights..If i select "All" and press "on" or "off" it turns all the light off and on. If I select Light 1 it says "Empty" that's true for all 1-18 of the light buttons..

[Steve Q]

Now go back and use "add to a key" to add each device back to whatever key you want. Its a pain, but there is no other way!

Steve Q

[dumpmyster]

Steve..Okay when I add a light to a key and it's asking for to select a digit, do I enter the digit of the node (node number)?

Here is what I'm doing:
Setup ->Light Setup ->OK->Add->OK->To a key->OK->Sel Digit..This is where I got stuck..

I figured it out..Okay when it's was asking for "Sel Digit"..I wanted my dining room light to be light number 1 on the controller so I select Light 1..Then the LCD said waiting..So what I did was turned z-wave switch on and off for my dining room light and that associated the dining room light to "Light 1" on the controller..Now for the rest of them!!!

Thanks Steve:-)