use switchlinc plugin or not

[TeleFragger]

Ok so normally i have alot installed and dont use most of it..

sooooo.
i have x10 23890w light switches all over the house... they work great...
well i had the switchlinc plugin installed... but never used it as it does what.. scenes???

ok so i have one of these and the companion switch on my basement steps....
I then have 3 of them at the base of the basement....controlling 3 different zones of lights...

so for gaming i can turn off front/dimm middle and turn back off...

but kids are always leaving the lights on...

so my question...

should i use the switchlinc plugin to tie all 4 of them together?

what i was going to do was simply use
powertrigger to double tap say B12 off.. that would trip B9,10,11 and 12 off.....

or will the switchlinc plugin do better?

i have redone it all as i just didnt like all the extra stuff i had installed.. now it is nice and clean... and going to try and keep it that way with the NEEDS..
funny the wife just walked into the kitchen telling the kids they left the lights on again.....

to which i do have 4 motion sensors ... 1 on steps ceiling going down... and 1 per zone... so i could even do after no motion... dim them then still no motion.. then turn them off....

[Rupp]

Events can accomplish this just fine so why add the extra package.

[TeleFragger]

Events can accomplish this just fine so why add the extra package.

that was my question.. i did do that already.. but for some reason i wasnt sure if someone was going to say... hey you could do it so much easier with this......