Have You tried the Yale manual? Vision makes the Yale locks...
Announcement
Collapse
No announcement yet.
Vision ZM1701 Doorlock with keypad EU-version
Collapse
X
-
Hi,
Got it to work in Homeseer and can lock/unlock it. Also assigned user codes. Couldn't find the option to allow certain usercodes access for certain times, so I removed the lock from the Z-Wave network.
Now when I try to add it again it doesn't even get picked up. Tried everything. Is there anyway to factory reset the device?
@Homeseer: Please add support for these pretty please!
thanks
Comment
-
Originally posted by lunkan View PostHow did you assign user codes? Only thing I can do is lock/unlock. Yale manual doesn't help. I'm also looks at a switch on the lock to reset but there is nothing!
2. Actually you can use any controller to Reset lock to "fabric default". Also HomeSeer. Just use "Remove device" feature.
Comment
-
Originally posted by hkmod25 View Post2. Actually you can use any controller to Reset lock to "fabric default". Also HomeSeer. Just use "Remove device" feature.
Comment
-
Originally posted by hkmod25 View Post1. You going to Root device (for your lock). After this you will see "User Codes" button (click to configure user codes for device)...
2. Actually you can use any controller to Reset lock to "fabric default". Also HomeSeer. Just use "Remove device" feature.
Comment
-
Originally posted by rsa View PostHi,
Got it to work in Homeseer and can lock/unlock it. Also assigned user codes. Couldn't find the option to allow certain usercodes access for certain times, so I removed the lock from the Z-Wave network.
Now when I try to add it again it doesn't even get picked up. Tried everything. Is there anyway to factory reset the device?
@Homeseer: Please add support for these pretty please!
thanks
Comment
-
Originally posted by lunkan View PostKnow that it's a little bit hard but the only way I could do this was to total erase the Z-stick II and then adding a new node. You should have the lock close to the stick. (only 5-10cm away)
Before I try to erase it, can you confirm that you can use the user/pin codes now with time restrictions i.e only let pin nr 2 work on Mondays?
thanks
Comment
-
alexmore
using original mortise
Originally posted by lunkan View PostAfter thinking a bit I will keep the lock and modify mortise lock to fit
Backset measurements is about 50 mm on my lock (swedish standard). I must shorten the whole mortise lock with 20 mm. This will include some cutting, drilling and welding.
Why dont use original mortise and only external and internal zm1701?
alex
Comment
Comment