Announcement

Collapse
No announcement yet.

Kwikset deadbolt install troubles

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Kwikset deadbolt install troubles

    Just bought 5 quikset deadbolts. Was having trouble getting them to install correctly, but found a thread that recommended taking them off the door and bring them to the computer and removing and adding the nodes that way. Seemed to work perfectly last night. Gotten all added, node info was correct, homeseer devices were created, and I could lock and unlocked deadbolts through the device status.

    Ran the optimizations a few times before I went to bed last night. Went to start creating events this morning, and when I go to the device status page, it has changed. Where last night I had a pull down menus for each lock to lock/unlock, today it just says on/off.

    What did I do?

    Btw, I am using a z-troller firmware 1.17 , Homeseer 2.5.0.52

    I also have 2 ACT Devices, 2 GE jason devices, and one intermatic device.

    Neighbor status is excellent on all but one device which is acceptable.

    Thanks,
Working...
X